Fast Curing 3+3 Brand Acetic and Neutral RTV Silicone Gasket Maker, 100g and 85g. With or Without Super Glue as Gift.
Applications:
Sealing and anti-shaking of engines, valve cages, bonnets and other mechanical parts in cars, motorcycles, farming machines, also, seal in high-temp fields, like in machinery, electronic, chemicals, and hardware, etc.
Technical Data Sheet:
How to use:
1. Clean all surfaces thoroughly. Remove old gaskets and prepare flange surfaces. Dry and remove all oil and grease
2. Remove the cap, puncture inner seal of the tube, screw on nozzle with a desired size
3. Apply continuous, uniform 1~4mm bead around perimeter of one surface. or completely surround all bolt holes
4. Wait about 10 minutes for glue to skin over. Then reassemble the parts
5. Gasket maker dries to touch in 1 hour and allow to bond after 24 hour fully curing.
Notes:
1. Clean the assembled parts by removing the oil and grease.
2. it will release some acid odor when assemble the parts, so using in an adequate ventilated place.
3. Screw the nozzle tightly after using in order to avoid its curing inside the tube
4.Keep away from children.
OEM service is highly welcome. We can customize 35g,55g,85g,100g and 310ml packing in blister card or box.
Applications:
Sealing and anti-shaking of engines, valve cages, bonnets and other mechanical parts in cars, motorcycles, farming machines, also, seal in high-temp fields, like in machinery, electronic, chemicals, and hardware, etc.
Technical Data Sheet:
Color: | Black, grey, red |
Specific gravity: | 1.00g/cm³ |
Tensile strength(GB/T528): | 1.3MPa(Room temperature) |
Elongation at break(GB/T528): | 200% |
Tack free time: | 5~15min |
Curing depth: | ≥2mm(24h) |
Temperature range: | -54~210ºC |
How to use:
1. Clean all surfaces thoroughly. Remove old gaskets and prepare flange surfaces. Dry and remove all oil and grease
2. Remove the cap, puncture inner seal of the tube, screw on nozzle with a desired size
3. Apply continuous, uniform 1~4mm bead around perimeter of one surface. or completely surround all bolt holes
4. Wait about 10 minutes for glue to skin over. Then reassemble the parts
5. Gasket maker dries to touch in 1 hour and allow to bond after 24 hour fully curing.
Notes:
1. Clean the assembled parts by removing the oil and grease.
2. it will release some acid odor when assemble the parts, so using in an adequate ventilated place.
3. Screw the nozzle tightly after using in order to avoid its curing inside the tube
4.Keep away from children.
OEM service is highly welcome. We can customize 35g,55g,85g,100g and 310ml packing in blister card or box.